Discussion on anything swift related. Got a new whip? Spotted a swift somewhere? Just want to shoot the breeze about your cars?
  • User avatar
  • User avatar
  • User avatar
User avatar
By Miniswift
Posts Avatar
#9824
It is actually part of the cylinder head.
Inlet side has been TIG welded to fill injector holes then inlet tube is machined off billet ali.
This billet ali tube is 45 degree to valve to make nice straight flow and port and polished same time. Just in case cylinder head was warped, it has skim. As a result, higher CR as well.

So this cylinder head is one off!
new job

:-o wow :-o i wrote a small list of items for t[…]

I have a complete set. I only installed the insid[…]

HVAC Foam Seals

Some images to go with. I'm not sure if he is sti[…]

RZCrew Garage Intakes

I have this saved on my car sites. Looks better m[…]